The full list
Every fitting TurboClad makes
24 fittings, grouped the way you meet them on a job. Every one is worked to the outside of the cladding — give it the pipe bore and the lagging thickness, or the finished diameter straight in — and it comes back as a true 1:1 flat pattern with the laps, lockforms and swages already on the cut.
Lobster backs, trunnions, flat back cones, square to round transformers, tank tops, dished ends. Print at actual size and scribe round the sheet, or take the mark-out table and set the job out with a rule and a scriber. It all runs offline, so a plant room with no bars makes no difference.
Bends
Two-piece mitres, segmented lobster backs, and bend onto bend.
- Mitred Elbow2-pieceFREE
- Lobster BackSegmented bendPRO
- Double BendBend onto bend · twistPRO
Tees & Branches
The hole in the main and the shaped end of the branch.
- TeeAny angle · any branchPRO
- One-Piece TeeMain + branch, one sheetPRO
- TrunnionSupport stub on a bendPRO
- Tee on ReducerBranch into a conePRO
- Tee on DomeBranch on a dished endPRO
- Tee on Tank TopBranch through a cone roofPRO
Reducers & Cones
Anywhere the line changes size.
- ReducerConcentric taperFREE
- Flat Back ConeEccentric reducerPRO
- Oblique ConeOffset-apex conePRO
- Angle ConeSmall end on a tilted planePRO
Transitions
Square or rectangular one end, round the other.
- Square to RoundTransition · concentricPRO
- Rectangle to RoundTransition · concentricPRO
- Oblique to RoundOffset transitionPRO
- Right Angle to RoundFlush side · plumb backPRO
- Oblique TransformerRound anywhere over the basePRO
Watershed Tops
Lids that throw the water off instead of holding it.
- Round TopWatershed cone lid · round boxPRO
- Tank TopSegmented cone roofPRO
- Valve EndWatershed peaked D lidPRO
Vessel Ends
Curved heads, developed as gores.
- DomeTwo-radii head · goresPRO
- Dished EndShallow cap · radius = ØPRO
- Hemispherical DomeHalf-ball · goresPRO
What you get without paying
The Mitred Elbow and Reducer and the standard pipe chart are free
Full size, no watermark, no account — print one and measure the calibration bar before you cut anything. The chart gives you DN, OD and 1D to 5D radii. Pro is the other 22 fittings, DXF export for the plasma and the laser, saved jobs you can reprint and your company name on every template.